But i'm just not sure what to set my at4033 at I finally got everything to work There's a low cut and a pad selection on the mic
What is a Condenser? How Does it Work ? 3 Types of Condensers
The low pad has a straight line for one choice and a straight line that dips down as the second choice
Has anyone experienced latency problems while using a usb condensor mic with sonar x1
I'm talking about delay when recording Like for example, you record your voice to the project's tempo, but the actual recordings have a slight delay and dont match up with the rest of the clips in the project (th. I was told by guitar center that the sterling audio st66 condenser mic is equivalent to the groove tubes gt66 and that the mics are made by the same mfr (aspen pittman). Previously i had set on the low cut switch for voice and guitar recording with good result
How about piano recording (indoor, no fan or aircond blowing directly) While i don't normally do so, sometimes when i'm using the mic, i just leave it connected for days in between recording I do shut down the system at night It's one of the behringer large diaphragm condenser mic
I can't get any signal through my id22 from an audio technica at4033se connected to either of the two xlr mic inputs
Flicking the phantom power switch on or off makes the meters move momentarily, but otherwise i get not even a faint signal from the mic even with the input level turned up full Is a boom arm necessary for a condenser mic placement or will a condenser mic work just fine with a mic stand What's a shock mount and is it necessary to use with a condenser mic Btw, this is for vocals.
I have a portable tascam dp 24 recorder, with 8 inputs at once, and would like to record a demo band in a practice studio and later mix it with sonar 3 mic for drums (one kick, 2 overheads), direct to tascam dp.1 mic for guitar amp, direct to tascam dp.1 di for bass guitar (x.
