Replace the ceiling light with control hub danger Support the frame until securely fastened Always disconnect the pod from the power outlet before you begin disassembly, maintenance, moving, or any other procedure.
Anastasia (@anastasiia___s) on Threads
The fan and light switch on for 3 seconds and then switch off
Enter the pod to see whether the fan and light switch on
If the fan and light do not switch on, the motion detector is faulty. Lift the table top into the pod upside down Install the cable holders with 3.5x16 screws (6 pcs) into the holes in the bottom of the table top. Unscrew the 3.5x16 screws (4 pcs) holding the fan module in its place
Lift the fan module out from the roof module and disconnect dc connectors Clean the fans with an air duster Do not apply excessive pressure or suction to the fan blades Clean the parts under the fan module with a vacuum cleaner and a cloth
Connect the dc connectors and install the fan module with 3.5x16 screws (4.
Install the guide pins (4 pcs) to the mounting holes of the floor modules Make sure that the flat side of the guide pin goes into the mounting hole Lift one wall module into place Support the wall until it is secured with the bolts
Install m8x35 bolts (4 pcs) and m8 washers (4 pcs) and tighten by. Topic page home framery q flip 'n fold installation program the door opener framery q meeting maggie flow flip 'n fold installation warranty checklist installation requirements floor Install guide pins (8 pcs) to the vacant holes on the back of the pod
