Just by replacing vision sensors it will not work The current rating of my mosfets are all higher than the old ones in the esc Professional calibration by specific tool is required
Contact any drone repair or service in your area i just wait, official calibration software support to change it
Like it is done in mini 3 pro.
I have put back together the entire gimbal already, and i would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely I am also looking for replacement philips 1 screws for the gimbal internals Does anyone have the specs on the screws? I'm sure that this must have been done numerous times in the past, but i'm darned if i can find any definitive description of how to do it anywhere
As the title suggests, i'm trying to figure out how to replace an alternator warning lamp with an led There are a couple of issues it seems Replacing the esc board is the single toughest repair on a mavic, but the op shows that it can be done Just be careful with all tee ribbon cables, dont damage them, and also dont let solder or flux splatter on to adjoining components
If that happens, you will get a short, and might never be able to identify it.
I need to replace both rear motors I don't want to disassembly whole drone, so i'm thinking about pulling out the motor from the arm, cut the wires and solder new motor I know this is possible, because i pulled my motor out, but i'm worried about antenna and it's signal wire, because. After research, i decide to try replacing the primary 6800uf 80v capacitors
After replacing the caps, the behavior has changed, but not really for the better. I'm just starting to get into electronics as a hobby and i was wondering if someone here could help me understand the process of replacing damaged microcontrollers With the right tools and practice, i could probably replace most components, even smds However, from what i understand, i cannot.
Replacing the lr arm axis was honestly a relatively easy repair
The roll motor buzzes lightly and stays engaged, providing resistance to the touch. Hello forum, i'm replacing the mosfets in an electronic speed control (esc) for rc cars My problem is, i don't really know what to look for when choosing the new mosfet
